[ 1.00.37]
	- added the code that supports the new mainboard for new laminator head, HitDevice
	- added the laminator head resistor value for supporting new laminator head, HitDevice
	- added the flag for new laminator head, HitDevice



[ 1.00.34]
	- added the function for cleaning by using the buttons on the front of printer after opening the top cover 


[ 1.00.31 ]
	- modified the downloading block size (1KB to 2KB) when the laminator firmware is being downloaded and updated (from the printer firmware ver. 1.10.47).
	- modified the laminator firmware is downloaded again from the start address when the laminator firmware's downloading and updating is failed (from the printer firmware ver. 1.10.47). 



[ 1.00.28 ]
	- fixed to adjust the flipper position again when card is moved into the laminator and card is ejected to the front side of the printer.
	- changed to enable to recognize the film under the condition that the width of division mark on laminating film is over 2mm (minimum).
	- changed that laminating is started when the laminator head's temperature is same with the setting temperature. 
	- changed that the card is accelerated every second when the card is being ejected.



[ 1.00.22 ]
	- changed to prohibit the overheating of Laminator head
	- added the error bits to check the overheating of Laminator head "E_HEAD_SAFETY (0x00040000)"
	- changed to routine of card-in action when bottom card in-> Laminating -> Back out movements in pipeline mode



[ 1.00.20 ]
	- fixed the minor bugs


[ 1.00.18 ]
	- added the value of flipper angle to be changed by end-user (Rotator Pos. range: -20 ~ 20)
	- added the commands between Printer and Laminator (ex. the command to change the status)
	- changed the routine of returning a card in Laminator
	- changed the routine of angle adjustment in flipper of Laminator



[ 1.00.11 ]
	- fixed the bug of laminating on top side when commanding to laminate on bottom side in pipeline mode



[ 1.00.09 ]
	- changed to stop the printer and display the error message at LCD when error occurs in Laminator



[ 1.00.06 ]

	- improved the card transport method of Laminator
