[ 1.02.11] - 181113

	- modified the time to run the WDT(WatchDogTimer)
	- divided the laminating start position into Upper and Lower



[ 1.02.05 ] - 180102

	- added the function to run the WDT(WatchDogTimer)



[ 1.01.64 ] - 170411

	- modified to set the ribbon stop torque (the fixed value was 150 before)
	- modified to get the temperature even if it is below 0 degrees C



[ 1.01.60 ] - 160713

	- added the function that flipper can attached to the left or right on Master Mode



[ 1.01.51 ] - 160126

	- fixed the bug that the multi termination error occurs by noise


